ACCO Brands Electric Heater H212 User Manual

HeatSeal  
H212/H312  
with SureFlowTechnology  
G
F
D
I
O
E
P
T
K
c
Instruction Manual  
Manuel d’utilisation  
Bedienungsanleitung  
Manuale d’istruzioni  
Gebruiksaanwijzing  
Manual de instrucciones  
Manual de Instruções  
Kullanım Kılavuzu  
Οδηγίες  
Brugsvejledning  
FI  
o
Käyttöopas  
NO  
o
Bruksanvisning  
S
Q
o
Bruksanvisning  
Instrukcja obsługi  
Návod k obsluze  
Használati útmutató  
CZ  
H
RUS  
o
Руководствo по  
зкcплyатации  
 
1
2
4
6
3
5
7
 
Safety instructions  
Important safeguards  
m
m
YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS IMPORTANT  
TO ACCO BRANDS EUROPE. IN THIS INSTRUCTION MANUAL AND ON  
THE PRODUCT ARE IMPORTANT SAFETY MESSAGES. READ THESE  
MESSAGES CAREFULLY.  
WARNING: FOR YOUR PROTECTION DO NOT CONNECT  
THE POUCH LAMINATOR TO ELECTRICAL POWER UNTIL  
YOU READ THESE INSTRUCTIONS COMPLETELY. KEEP  
THESE INSTRUCTIONS IN A CONVENIENT LOCATION FOR  
FUTURE REFERENCE. TO GUARD AGAINST INJURY, THE  
FOLLOWING BASIC SAFETY PRECAUTIONS MUST BE  
OBSERVED IN THE SET-UP AND USE OF THIS PRODUCT.  
m
THE SAFETY ALERT SYMBOL PRECEDES EACH SAFETY  
MESSAGE IN THIS INSTRUCTION MANUAL.  
m
THIS SYMBOL INDICATES A POTENTIAL PERSONAL  
SAFETY HAZARD THAT COULD HURT YOU OR OTHERS,  
AS WELL AS CAUSE PRODUCT DAMAGE OR PROPERTY  
DAMAGE.  
General safeguards  
• Use the unit only for its intended purposes of laminating documents.  
THIS WARNING IS FOUND ON THE PRODUCT.  
• Do not place anything in the throat opening of the laminator other than  
pouches/documents.  
WARNING  
cm  
Electrical shock hazard.  
• Place unit on a secure, stable work area to prevent the unit from  
falling and possibly causing personal injury and damage to the unit.  
Do not open. No user  
servicable parts inside.  
Refer servicing to qualified  
service personnel.  
• Follow all warnings and instructions marked on the unit.  
• The socket outlet shall be installed near the equipment and shall be  
easily accessible.  
• Do not attempt single side lamination, this will destroy the laminator.  
• Do not block the vent slots, this will cause the laminator to overheat.  
This safety message means that you could be seriously hurt or killed if  
you open the product and expose yourself to hazardous voltage.  
The following ISO and IEC symbols appear on this product, and their  
meanings are as follows:  
Electrical safeguards  
• The unit must be connected to a supply voltage corresponding to the  
electrical rating shown on the unit.  
On / Off  
Release  
Cold  
Heat  
• Unplug the unit before moving it, or when it is not in use for an  
extended period of time.  
• Do not operate with a damaged supply cord or plug. Do not alter the  
attachment plug. The plug is configured for the appropriate electrical  
supply.  
Special notice  
• Do not overload electrical outlets beyond their capacity; fire or  
electrical shock could result.  
Thank you, for your recent purchase of a GBC Pouch Laminator. Your  
new laminator may emit a slight odour during the initial stage of  
operation. It is normal and will diminish after several hours of operation.  
• The unit is intended for indoor use only.  
• Never push objects through the cabinet slots. Do not spill liquid of any  
kind on this product.  
Cleaning  
• Close supervision is required when this product is used near children.  
Caution: Unplug this product before cleaning.  
m• Wipe exterior only with a damp cloth. Do not use detergents  
or solvents.  
Service  
• Do not use aerosol dusters or cleaners.  
• Do not spray anything into the machine.  
• Do not attempt to service or repair the pouch laminator yourself.  
Unplug the unit and contact an authorised ACCO Brands Europe  
service representative for any required repairs.  
Specifications  
GBC HeatSeal H212  
GBC HeatSeal H312  
230V / 50Hz / 2Amps / 500W  
476x173x117mm  
3.9kg  
Electrical  
230V / 50hZ / 2Amps / 500W  
400 x 173 x 117.5mm  
3.1kg  
Machine Dimensions  
Machine Weight  
Maximum Pouch Width  
Maximum Pouch Thickness  
Maximum Thru-put Thickness  
Warm-Up Time (2 x 75 mic)  
241mm  
318mm  
2 x 125 mic (Total 250)  
0.8mm  
2 x 125 mic (Total 250)  
0.8mm  
5 minutes  
5 minutes  
 
G
Important: Before operating your new laminator, lift up the exit tray located at the rear of the machine and lock it in place (fig. 1).  
Operation, hot lamination  
1
2
4
5
Connect power cord to appropriate power source.  
A series of four beeps will be heard when laminator reaches  
operating temperature.  
Push the power button to turn the power “ON” (fig. 2). The  
indicator will glow red.  
Position the document to be laminated into a GBC laminating pouch,  
so that the document is aligned to the folded sealed edge and the  
right and left borders are equal (fig. 4).  
3
Using the lamination guidelines (fig. 3), select the appropriate  
temperature setting for the pouch gauge thickness and material you  
are laminating.  
6
7
Insert the pouch and its contents straight into the machine, leading  
with the folded edge.  
• If the laminated item appears to be cloudy, it means that the  
laminator temperature is not hot enough. Allow the laminator to  
heat for a few more minutes then run the pouch through again.  
The laminated item will automatically exit the rear of the machine.  
After the pouch has stopped moving, immediately place it on a flat  
surface to cool for one minute before handling (fig. 5).  
• If the laminated item is wavy, the TEMPERATURE is too hot. Verify  
temperature selector is set at the appropriate temperature.  
8
If you have finished laminating, push the switch to turn “OFF” the  
machine.  
• Always allow sufficient time for the laminator to adjust to changes  
in temperature setting.  
DO NOT LAMINATE AN EMPTY POUCH  
Operation, cold lamination  
1
4
5
Connect power cord to appropriate power source.  
A series of four beeps will be heard when the laminator is ready to  
use.  
2
3
Rotate the temperature dial to the “cold” position (fig. 2).  
Use and laminate your GBC cold pouch.  
(Pressure sensitive—non-thermal laminating pouch)  
Push the power button to turn the power “ON” (fig. 2), the  
indicator light will glow red.  
Release lever  
4
5
How to use the release lever.  
Clean the rollers by running the cleaning sheet supplied with the  
laminator through the machine 2 or 3 times in the hot operation  
mode (red zone on temperature dial). If you do not have this sheet,  
use a similar cardboard sheet that fits the width of the laminator.  
1
2
If pouch jams or is fed improperly, turn off the laminator immediately.  
Press the release lever down to release the motor from the rollers  
(fig. 6).  
Continue laminating.  
3
Pull your document back out of the laminator while pressing the  
release lever down (fig. 7).  
Helpful lamination hints  
1
3
4
Temperature setting Guidelines:  
Do not attempt to do single sided lamination. This will destroy the  
laminator.  
When laminating thin paper with light ink coverage, set the  
temperature dial at the low end of the range. Thick paper and heavy  
ink coverage require higher settings. Temperature settings will vary  
due to the finish, chemistry and heat absorption properties of the  
material being laminated.  
As soon as the lamination is completed, remove from the rear of the  
machine and place on a cool flat surface for cooling to prevent the  
pouch from curling.  
5
Do not block the vent slots, this will cause the laminator to overheat.  
2
Before laminating important or unique documents always run a test  
pouch through the laminator using a similar type document.  
Guarantee  
Operation of this machine is guaranteed for two years from date of  
purchase, subject to normal use. Within the guarantee period, ACCO  
Brands Europe will at its own discretion either repair or replace the  
defective machine free of charge. Defects due to misuse or use for  
inappropriate purposes are not covered under the guarantee. Proof  
of date of purchase will be required. Repairs or alterations made by  
persons not authorised by ACCO Brands Europe will invalidate the  
guarantee. It is our aim to ensure that our products perform to the  
specifications stated. This guarantee does not affect the legal rights  
which consumers have under applicable national legislation governing  
the sale of goods.  
Register this product online at www.accoeurope.com  
 
Service  
G
ACCO Service Division  
Freepost 193, Hereward Rise, Halesowen, West Midlands, B62 8AN.  
N
I
Sannum & Stang  
Gladengveien 16 0661 Oslo.  
Tel: +4722685940, Fax: +4722686730, e-mail: [email protected]  
ACCO UK Sales International  
Oxford Road, Aylesbury, HP21 8SZ.  
Tel: 00 44 1296 397444, Fax: 00 44 1296 311000  
ACCO Italia Spa  
Via Nenni 13, Settimo Torinese (TO) Via Regio Parco 10B/bis.  
Tel: 011 896 11 11, Fax: 011 896 11 12  
IRE  
F
O
B
D
ACCO France  
o
ACCO-Rexel Ltd  
Clonshaugh Business & Technology Park, Clonshaugh Dublin 17.  
Tel: 01 816 4300, Fax: 01 816 4302  
Service Aprés-Vente, 8 Rue du 19 Mars 1962, 21601 Longvic, Cedex BP7/ZI.  
Tel: 0802 872 356, Fax: 03 80 68 60 49  
ACCO Benelux  
Peppelkade 64, 3992AK Houten.  
Q
S
ACCO Polska Sp. z o.o.  
Al-Jerozolimskie 184, 02-486 Warszawa.  
Tel: +42 22 570 18 01, Fax: +48 22 570 18 33  
ACCO Benelux (Technische Dienst)  
Peppelkade 64, 3992AK Houten, Nederland.  
ACCO Nordic Region  
Kontor 1, i norden AB Kanalvägen 16 194 61 Upplands Väsby.  
Tel: 08 444 5191, Fax: 08 444 5199  
FI  
o
ACCO Deutschland  
H ATernl:o+ld4s9tra-s7s1e851,/7838671-146S0c,oFranxd:o+rf4,9Ge-r7m1a8n1y./887-165  
Somen Huoltopalvelu oy  
Kanaamouka 1 00360 Helsinki. Tel: 956 050 510, Fax: 956 050 500  
RUS  
o
E
CZ  
o
A
S
XERTEC a.s.  
P AIsCaaCcOPIebrearli1a9S, L28820 Coslada (Madrid). Tel: 91 669 9391, Fax: 91 672 07 11  
U Továren 770/1b, 102 00, Praha 10.  
g
Oddi  
Höfdabakka 3-7 IS-112 Reykjavik. Tel: 00354 515 5000, Fax: 00354 515 5101  
ACCO Österreich  
Sallmann Bürotechnik GmbH, Esshaverstrasse 16, 5020 Salzburg.  
Tel: 0662 4345 160, Fax: 0662 4345 164, e-mail: [email protected]  
T
Eraysan  
Ankara Cad N.129, Sirkeci, Istanbul.  
Tel: 0090 212 6591686, Fax: 0090 212 5226992, [email protected]  
ACCO Schweiz  
AUS  
o
ACCO Australia Pty.  
Level 2 Building B, 8 Lord Street, Botany. NSW. Australia 2019.  
Tel: 2 9700 0180, Fax: 2 9700 0195  
ABC Bürotechnik AG, Winkelbüel 4, 6043 Adligenswil.  
Tel: 041 375 6060, Fax: 041 375 6061,  
c
Mailtech  
Baldersbaekvej 8B 2635 Ishoj.  
Tel: 045 43 73 37 37, Fax: 0045 43 73 73 37 07, e-mail: [email protected]  
ACCO Brands Europe  
Oxford House  
Aylesbury HP21 8SZ  
United Kingdom  
Ref: H212H312/5276  
Issue: 1 (01/07)  
 

3Com Switch 5500 EI User Manual
Acer Laptop 290E User Manual
Agilent Technologies Water Dispenser 4155B User Manual
Altec Lansing Compact Loader MP450 User Manual
Audiovox Car Stereo System ACD17 User Manual
Axor Plumbing Product 4406XX0 User Manual
Azden Microphone 105LH User Manual
Baldor Computer Hardware EXB009A01 User Manual
Barco Computer Monitor MFGD 2320 User Manual
Beko Clothes Dryer DRVS 73 S User Manual