VEC0 1 3 DB
Jump-Start System
12VOLT DC POWER SUPPLY
O W N ER’S MAN UAL AN D
WARRAN TY IN FO RMATIO N
3. Never insert anything other than the supplied power/ recharging cords or
recommended appliance power/ recharging cords into the 12 volt DC charging/
power socket on this unit. Do not use any accessory that is not recommended
or provided by the manufacturer.
4. Do not use this unit to operate appliances that draw more than 5 amps.
5. This system is designed to be used only on vehicles with 12 volt DC battery
systems. Do not connect to a 6 volt or 24 volt battery system.
6. This system is not designed to be used as a replacement for a vehicular battery.
Do not attempt to operate a vehicle that does not have a battery installed.
7. Vehicles that have on-board computerized systems may be damaged if vehicle
battery is jump-started. Before jump-starting, read the vehicle’s owners manual to
confirm that external-starting assistance is advised.
8. Excessive engine cranking can damage a vehicle’s starter motor. If the engine
fails to start after the recommended number of attempts, discontinue jump-start
procedures and look for other problems that may need to be corrected.
9. Although this unit contains a non-spillable battery, it is recommended that unit be
kept upright during storage, use and recharging. To avoid possible damage that
may shorten the unit’s working life, protect it from direct sunlight, direct heat
and/ or moisture.
10. Check unit periodically for wear and tear. Replace worn or defective parts
immediately. Contact Durabilt’s Customer Service department toll-free (800) 916-
7004.
11. Do not attempt to jump-start a frozen battery.
12. Never submerge this unit in water.
FIRST AID:
SKIN: If battery acid comes in contact with skin, rinse immediately with running water,
then wash thoroughly with soap and water. If redness, pain or irritation occurs,
seek immediate medical attention.
EYES: If battery acid comes in contact with eyes, flush eyes immediately - for minimum
of 15 minutes - seek immediate medical attention.
IMPO RTAN T:
Although this unit is delivered in a partially charged state, you must fully charge it
with the supplied 120 volt AC charger for a full 48 hours before using it for the first
time. You cannot overcharge the unit using the AC charger method.
CAUTIO N S:
Do not expose to rain. Replace defective cords or wires immediately.
SAVE THESE IN STRUCTIO N S
2
IN TRO DUCTIO N
Congratulations on selecting the Durabilt Jump-Start System. This compact jump-
starter is unique in the amount of energy it can supply for its size. The internal battery
is a high-density sealed, lead-acid battery that stores and delivers energy
comparable to full sized ordinary jump-starters. Please read this guide carefully
before use to ensure optimum performance and avoid damage to the unit or items
that you are using it with.
The Durabilt Jump-Start System is a compact, durable and portable jump-start
system for vehicles and boats that have a standard 12 volt battery system. This self-
contained, rechargeable system will start most vehicles and boats without the need
for a host vehicle or 120 volt AC power supply. It can also be used as a safe,
portable source of 12 volt DC electric power in remote locations and/ or
emergency situations. It is ideal for use with Durabilt 12 volt DC cordless, portable,
rechargeable products.
Use th e Dura b ilt Jum p -Sta rt System to :
•
Jump start any engine system with a standard 12 volt DC battery: boat; truck; car;
airplane; RV; personal watercraft; snowmobile; garden tractor; gasoline engine
generator, etc.
•
Operate: 12 volt DC fans, inflators, fluorescent worklights, cellular phones (can
quick-charge a cellular phone by using the phone’s 12 volt DC adapter cord),
spotlights, TVs, portable radios, cassette or CD players, and more.
The Jump-Start System has an easy-to-read series of LED (Light Emitting Diode) charge
indicators that show when the unit is fully charged, or the level of charge in the battery.
Charge level can be viewed when the charge status push button is pressed. A 12 volt
DC power accessory socket is provided for use with appliances that can operate from
a vehicle 12 volt DC accessory outlet. This allows maximum portability and utility
when the Jump-Start System is used in remote locations.
The Jump-Start System can be recharged from any standard 120 volt AC power
source using the supplied AC Recharge Adapter. The adapter barrel connector
attaches to the Recharge Port on the top panel of the jump-starter. A built-in 12 volt
appliance socket and the appropriate DC/ DC charging/ adapter cord is used to
recharge the battery from another 12 volt DC source. When pressed, the CHARGE
STATUS button will show the battery power level status (from Low to Full). The green
LED full indicator illuminates when the unit is fully recharged and charging can be
discontinued. An ON/ OFF switch operates the built-in work/ emergency light.
3
10
1
2
3
4
5
6
7
8
9
FIGURE 1 A (Front Panel View)
FIGURE 1 B (Rear View)
1. 12 Volt DC Accessory Socket for DC appliances (with overload protection)
2. Battery Level Status Pushbutton
3. LED Charging/ Battery Level Indicators
4. ON/ OFF Power Switch
5. Recharging Port
6. Area Light
7. Area Light ON/ OFF Switch
8. Negative (Black) Jumper Cable
9. Positive (Red) Jumper Cable
10. Clamp Holder Tabs
ADDITIO N AL FEATURES
•
Includes non-spillable, maintenance-free, heavy-duty, new high energy density
17 Amp hour, sealed battery.
•
•
•
•
•
Safe to use, transport, and store.
Requires no maintenance (other than recharging) for optimum operation
Automatic taper charge for AC recharge
Molded high-impact case is tough and durable
Built-in emergency worklight with for roadside repairs and use in remote
locations without utility power
CAUTIO N : Use only adapters supplied with this unit. Never insert any other
adapters into the charging or power receptacles on this unit.
4
JUMP STARTIN G IN STRUCTIO N S
N O TE:
CAUTIO N :
WARN IN GS:
1. Before using this system to jump-start any vehicle or boat, read and understand
all instructions, safety tips, warnings, cautions and first aid information
provided in this manual and on the product labeling. Additional important
information may also be provided by the vehicle’s battery system manufacturer.
2. Be aware of first aid procedures before attempting jump-start procedure.
3. Always wear protective eyewear when working with a lead acid-type battery.
4. Do not smoke or use inflammable items (matches, cigarette lighters, etc.) while
working on a vehicle’s battery system.
5. When using this jump-starter in proximity to the vehicle’s battery and engine,
stand the unit on a flat, stable surface, and be sure to keep all cords and cables
away from any moving parts.
5
RECO MMEN DATIO N S FO R O PTIMUM PERFO RMAN CE O F THE
DURABILT JUMP-START SYSTEM
CAUTIO N :
1. To avoid possible damage that may shorten the unit’s working life, protect this
unit from direct sunlight, direct heat and moisture.
2. This system is to be used ONLY on vehicles, boats, garden tractors and gasoline
powered generators with 12 volt DC battery systems.
3. This system is NOT designed to be installed as a replacement for a vehicle battery.
4. Vehicles that have on-board computerized systems may be damaged if vehicle
battery is jump-started. Before jump-starting this type of vehicle, read the vehicle
owner’s manual to confirm that external-starting assistance is advised.
5. Excessive engine cranking can damage the vehicle’s starter motor. If the engine
fails to start after the recommended number of attempts, discontinue jump-start
procedure and look for other problems that may need to be corrected.
6. Check unit periodically for wear and tear. Replace worn or defective parts
immedia tely; conta ct Dura bilt Customer Service Depa rtment toll-free:
(800) 916-7004.
7. Do not attempt to jump-start a frozen battery.
8. NEVER submerge this unit in water.
9. Do not wear vinyl clothing when jump-starting a vehicle, friction can cause
dangerous static electricity sparks. Remove all jewelry or metal objects, they can
cause short circuits or react with battery acid to cause severe burns. Remove
or secure any loose clothing, and restrain long hair, before attempting jump-start
procedure.
10. Lead-acid batteries generate hydrogen gas during normal operation. More gas
is generated when the battery is charging. Hydrogen gas is explosive,
poisonous to breathe and highly flammable.
6
WARN IN G:
FIRST AID:
S
KIN: If battery acid comes in contact with skin, rinse immediately with running water,
then wash thoroughly with soap and water. If redness, pain or irritation occurs,
seek immediate medical attention.
EYES: If battery acid comes in contact with eyes, flush eyes immediately - for minimum
of 15 minutes - seek immediate medical attention.
CHARGIN G/ RECHARGIN G
For maximum battery life, we recommend the Durabilt Jump-Start System be kept
fully charged at all times. If the battery is allowed to remain in a discharged state,
battery life will be shortened.
N O TE: Recharging battery after each use will prolong battery life; frequent
discharges between recharges will reduce battery life.
Charge up to 48 hours to reach full charge.
IMPO RTAN T: MAKE SURE ALL SWITCHES ARE TURNED OFF DURING
RECHARGING.
1 2 0 Vo lt AC Ch a rg in g
Charge unit for full 48 hours using AC method, prior to first use
Recharge unit fully after each use
1. Simply plug the AC plug of the AC/ DC adapter/ charger into any standard 120
volt AC wall outlet.
2. Plug the barrel connector attached to the AC adapter/ charger into the small barrel
receptacle on the jump-starter that is marked recharge port.
3. When charging is completed and the FULL light is on, remove the AC/ DC
charger plug and store in a safe place.
N O TE: The unit cannot be overcharged using the AC method. The Durabilt Jump-
Start System also comes with a DC/ DC charging adapter for recharging the
unit from a 12 volt DC accessory outlet in a vehicle or boat.
AC ADAPTER/CHARGER
WARN IN G: Do not recha rge for more tha n 4-5 hours ma ximum using
12 volt DC method
7
1 2 VO LT DC CHARGIN G
1. Insert the plug that is marked “TO VEHICLE ACCESSORY OUTLET” of the DC/ DC
charging adapter into the 12 volt DC accessory receptacle on the vehicle or boat.
2. Insert the plug at the other end of this charging adapter marked “TO JUMP
STARTER OUTLET” into recharging port on the front panel of the unit.
3. Charge the unit until the green FULL indicator lights when Charge Switch
Indicator Button is pressed. DO NOT EXCEED 4-5 HOURS MAXIMUM.
4. When charging is completed, remove the power cord and store in a safe place.
DC/DC CHARGER/ADAPTER
USE THIS PLUG ONLY FOR VEHICLE’S ACCESSORY OUTLET
OPERATION AS A 1 2 VOLT PORTABLE POWER SUPPLY
1. Lift up the cover of the unit’s 12 volt DC accessory receptacle (See Figure 1A).
2. Insert the 12 volt DC plug from the appliance into the receptacle on the unit.
3. Switch on the appliance, and operate as usual.
CAUTIO N : DO NO T USE THIS UNIT TO O PERATE APPLIANCES THAT
DRAW MO RE THAN 5 AMPS DC.
EMERGEN CY W O RKLIGHT
The area light is controlled by an On/ Off switch. Make sure the area light is turned
OFF when the unit is being recharged or stored.
REPLACEMEN T PARTS
For replacement parts (bulbs, batteries, fuses, etc.), contact Durabilt Customer
Service: toll-free (800) 916-7004.
Ba tte ry Re p la ce m e n t
It is recommended that the unit be returned to Durabilt Customer Service for
battery replacement: Contact or toll-free (800) 916-7004.
WARN IN G
• Do not dispose of the battery in fire as this may result in an explosion
• Before disposing of the battery, protect exposed terminals with heavy-duty
electrical tape to prevent shorting (shorting can result in injury or fire)
• Do not expose battery to fire or intense heat as it may explode
8
Ba tte ry Disp o sa l:
This unit contains a maintenance-free, non-spillable, sealed lead-
acid battery. This battery is fully recyclable and should be
accepted at any location that accepts common automotive starter
batteries. Examples of places that accept these batteries are:
County or municipal recycling drop-off centers, scrap metal dealers
and retailers who sell automotive replacement lead acid starter
ba tteries. For more informa tion on recycling this ba ttery,
call toll-free (877) 288-7722.
CAUTIO N : THIS PLUG USES AN 8 AMP FUSE.
PRO TECTIO N AGAINST RISK O F FIRE, REPLACE FUSE O NLY
W ITH SAME TYPE AND RATING.
FO R CO NTINUED
T0 REPLACE FUSE:
1. Remove plug from accessory receptacle. Remove the gold cap by turnng
counterclockwise and lifting off.
2. Remove center pin and spring. Remove fuse.
3. Replace fuse with same type and size fuse (8 amp).
4. Replace center pin and spring inside plug.
5. Replace gold cap by turning clockwise onto plug.
SPECIFICATIO N S
Model No . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . VEC013DB
Boost Ampere . . . . . . . . . . . . . . . . . . . 400 Instantaneous Cranking Amps
Battery Type . . . . . . . . . . . . . . . . . . . .12 Volt, 17AH Sealed, Rechargeable
Non-Spillable, Lead-Acid
Jumper Cables . . . . . . . . . . . . . . . . . . . . . . . .Heavy Duty, Welding Cable
Area Light . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . White LEDs
DC Charging Adapter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12 Volt DC
AC Charging Adapter . . . . . . . . .120 Volt AC (700mA, 12 Volt DC Output)
12 Volt Outlet Output . . . . . . . . . . . . . . . . . . . . . . . . . .Overload Protection
9
2 YEAR LIMITED WARRAN TY PRO GRAM
RETURN/ REPAIR POLICY:
LIMITATIONS:
STATE LAW RIGHTS:
TO REQUEST WARRANTY SERVICE FOR THIS PRODUCT:
WARRANTY ACTIVATION:
ATTN.: CUSTOMER SERVICE
4140 SW 28th Way, Ft. Lauderdale, FL 33312
TOLL FREE: (800) 916-7004
WARRANTY IS NON-TRANSFERABLE AND NON-REFUNDABLE
RD122904
|