Warranty
MEDIA AIR CLEANER LIMITED TEN-YEAR WARRANTY
®
This limited warranty covers Fedders Unitary Products Residential Type Media Air Cleaners,
excluding door latch, disposable media cartridge, charcoal filter, accessories, ductwork, and
installation. CareCo warrants that all new Trion Media Residential Air Cleaners are free from
defects in material and workmanship under normal, noncommercial use and service. Trion will
remedy any such defects if they appear within ten years from the date of original installation as
evidenced by Proof of Purchase from an Authorized Trion Dealer, subject to terms and conditions
of this Limited Ten-Year Warranty stated below:
Air BearTM Supreme
Series
Duct Mount
Media Air Cleaner
1. THIS LIMITED TEN-YEAR WARRANTY IS GRANTED BY CARECO, 415 WABASH AVE., P.O.
BOX 200, EFFINGHAM, IL 62401.
2. This warranty shall extend only to any noncommercial owner who has purchased the
residential Media Air Cleaner other than for purposes of resale.
3. All components are covered by this limited warranty except expendable items such as
charcoal filters and filter cartridges.
4. If within the warranty period, any Trion residential Media Air Cleaner unit or component
requires service, it must be performed by a competent heating and/or air conditioning
contractor (preferably the installing contractor). CareCo will not pay shipping charges or
labor charges to remove or replace such defective parts or components. If the part or
component is found by inspection to contain such defective material and workmanship, it
will be either repaired or exchanged-free of charge at CareCo’s option, and returned
freight collect.
5. In order to obtain the benefits of this limited ten-year warranty, the owner must notify the
dealer or distributor in writing or by phone, of any defect within 30 days of its discovery. If
after reasonable time you have not received an adequate response from the dealer or
distributor, notify in writing: CareCo Warranty, 415 Wabash Avenue Effingham, IL 62401 or
e:mail to: [email protected]
Installation • Operation • Maintenance
6. This limited warranty does not apply to any part or component that is damaged in transit
or when handling, has been subject to misuse, neglect or accident, has not been installed,
operated and serviced according to Fedders Unitary Product’s instruction, has been
operated beyond the factory rated capacity, or altered in any such way that its performance
is affected. There is no warranty due to neglect, alteration or ordinary wear and tear.
Fedders Unitary Product’s liability is limited to the replacement of defective parts or
components and does not include the payment of labor charges to remove or replace such
defective parts.
7. CARECO WILL NOT BE RESPONSIBLE FOR LOSS OF USE OF ANY PRODUCT, LOSS OF TIME,
INCONVENIENCE, OR ANY OTHER INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES
WITH RESPECT TO PERSON OR PROPERTY, WHETHER AS A RESULT OF BREACH OF
WARRANTY, NEGLECT OR OTHERWISE. SOME STATES DO NOT ALLOW THE EXCLUSION OR
LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE LIMITATION OR
EXCLUSION IN THE PRECEDING SENTENCE MAY NOT APPLY TO YOU.
8. THIS WARRANTY GIVES YOU SPECIFIC RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS
WHICH VARY FROM STATE TO STATE.
9. Any warranty (express, implied or statutory), representation, or guarantee other than those
set forth herein, shall expire at the expiration date of this express limited warranty. SOME
STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO
THE LIMITATION IN THE PRECEDING SENTENCE MAY NOT APPLY TO YOU.
10. Fedders Unitary Products reserves the right to make changes in the design and material of
its products without incurring any obligation to incorporate such changes in units
manufactured before the effective date of such a change.
CAUTION:
READ INSTALLATION, OPERATION, AND MAINTENANCE
INSTRUCTIONS CAREFULLY FOR SAFE OPERATION.
CareCo
415 Wabash Ave., P.O. Box 200, Effingham, IL 62401,
Phone: 1-866-829-2440
155595-010 7-04
email: [email protected]
10
Maintenance
Introduction
Your media air cleaner is a high efficiency air filtration device designed
to remove dirt, dust, pollen and other microscopic particles from the air
passing through it.
How to Maintain Your Air Cleaner
The media filter cartridge in your air cleaner must be replaced
periodically. The frequency of filter replacement is best
determined by visual examination. On average, filter cartridges
should be replaced every 9-12 months with normal usage.
How the Air Cleaner Works
Dirty air enters the air cleaner by way of the return air duct system in
your home. Particles are collected by the special pleated filter media.
The pleats provide an exceptionally large filtering face area in a very
compact space which allows maximum dirt holding capacities with
minimum air flow resistance.
STEPS FOR REPLACING FILTER CARTRIDGE
1. Open access door by pulling the handle. Remove door
completely.
2. Pull used filter straight out of cabinet and place to side.
3. Remove new filter cartridge from plastic bag and save the
bag.
4. Slide new filter cartridge into cabinet with “AIR-FLOW”
arrow pointing in the direction of airflow.
5. Replace door and place used filter in plastic bag for easy
disposal.
POLLEN & SPORES
DIRT & DUST
Replacement Filter Cartridges For Your Media Air Cleaner
Remember, periodic inspection and replacement of your filter
will ensure high efficiency air cleaning. Contact your HVAC
dealer for replacement filter cartridges.
GREASE & SOOT
Replacement
Filter Cartridge
Part Number
Number of
Filters Per
Carton
CLEAN
AIR
Air Cleaner Model
Filter Cartridge Size
5 x 19 3/4” x 20 3/4”
Air Bear Supreme 1400
20 x 20
255649-103
4
3
3
Air Bear Supreme 1400
16” x 25”
255649-105
255649-102
5 x 15 3/4” x 24 1/4”
5 x 19 3/4” x 24 1/4”
Air Bear Supreme 2000
20” x 25”
8
1
Unit Diagram
Installation
Air Bear Supreme 2000 (20” x 25” x 5”)
Air Bear Supreme 1400 (16” x 25” x 5”)
Air Bear Supreme 1400 (20” x 20” x 5”)
Physical Installation
The air cleaner cannot be installed with the access door facing down. The
section entitled Typical Mounting Positions (pg.4) shows examples of proper
air cleaner mounting with a variety of furnace installations.
Prior to Installing this Product
1. Read rules and instructions carefully for safe operation. Failure to follow
them could damage the product or cause a hazardous condition.
2
2. Check the ratings given on the product to make sure it is suitable for
your application.
3. Remove the old furnace filter and discard.
4. The air cleaner cannot remove existing dirt from the blower and ducts.
Clean the area thoroughly before beginning installation.
NOTE:
The following is a typical installation of the air cleaner on a highboy furnace.
You may have to alter the installation to fit your specific application.
1
5. Locate the cabinet in the cold air return duct such that all of the return
air flows through the unit. If the furnace and air cleaner openings are
different, use a transition.
3
6. Mounting holes are provided in the air cleaner cabinet for ductwork
attachment. The .140” diameter holes are sized for #8 sheet metal
screws, or 1/8” rivets. If the adjoining ductwork is flanged, install the
screws with the screw heads inside the cabinet, to prevent damage to
the filter cartridge during removal and installation.
1. Cabinet
7. Remove the plastic bag from the filter cartridge and replace filter
cartridge in cabinet.
2. Filter Cartridge
3. Access Door
8. After the unit has been secured, seal seams air tight with duct tape or
caulking. Reinstall access door to ensure a tight seal.
Capacity Selection Guide
Air Bear Supreme
Air Bear Supreme
1400 (16” x 25”)
Air Bear Supreme
2000 (20” x 25”)
Model
Air flow (CFM)
600
1400 (20” x 20”)
Resistance (Inches W.G.)
.04
.08
.12
.18
.24
.
.04
.08
.12
.18
.24
.
.03
.05
.07
.10
.14
.18
.22
.27
800
1000
1200
1400
1600
.
1800
.
.
2000
.
2
7
Installation
Dimensions
Turning Vanes
If the air cleaner is installed adjacent to a 90° duct elbow, add turning vanes inside
the duct to improve the air distribution across the face of the air cleaner.
Direction of Air Flow Through the Air Cleaner
The air cleaner is set up for left to right air flow, when facing the access door. For
right to left air flow remove filter cartridge, turn it around and replace in cabinet.
The directional arrows on the filter cartridge must point in the direction of air
flow.
Air Bear Supreme
1400
Model
Air Bear Supreme Air Bear Supreme
Humidifiers
1400
16”x25”x5”
455602-119
600-1400
2000
20”x25”x5”
455602-019
600-2000
Location of the system humidifier is important to the operation of the air cleaner.
When an evaporative type humidifier is used, it may be installed between the
furnace warm air duct and the return air duct without affecting the air cleaner.
Atomizing and spray type humidifiers should be installed downstream of the air
cleaner. If the humidifier must be installed upstream, allow at least 6 feet
between the air cleaner and humidifier.
20” x 20” x 5”
455604-019
600-1400
Filter Cartridge
Part Number
Air Flow (CFM)
Dimensions
7 1/8” (181mm)
24 7/8” (632mm)
7 1/8” (181mm)
24 7/8” (632mm)
7 1/8” (181mm)
21 3/8” (543mm)
20 1/4” (514mm)
A
B
16 1/4” (413mm) 20 1/4” (514mm)
C
Duct Opening
22 1/2” (572mm)
13 7/8” (352mm)
22 1/2” (572mm)
17 7/8” (454mm)
19” (483mm)
D
E
17 7/8” (454mm)
Filter Cartridge
Replacement
9-12 months between changes
UL class 2
6
3
Installation
Installation
Application
TYPICAL MOUNTING POSITIONS
This air cleaner is used in forced air heating, cooling, and ventilating
(Air cleaner shown shaded in illustrations)
systems. The air cleaner should be installed in the system such that all the
system air is circulated through the air cleaner. Maximum performance is
obtained with the system blower set for continuous operation.
WARNING
Installation Requirements
Before making changes to a HVAC system
that may affect the ventilation of
fuel-burning appliances, contact your
heating contractor.
The best location for the air cleaner is in the return air duct next to the
blower compartment. In this location, the blower motor and cooling coils
will be kept clean. Do not install the air cleaner in the discharge air duct.
Before installing the air cleaner, consider the application. If a transition
between the ductwork and air cleaner is required, refer to section entitled
Transitions, below. The unit must be readily accessible for periodic
inspection and replacement of the filter cartridge to maintain maximum
efficiency and trouble-free operation. A clean coil will reduce utility costs
by maintaining the coil’s efficiency. Failure to replace filter cartridge can
cause damage to the cooling system. Allow a minimum of 26” clearance in
front of the access panel for filter cartridge replacement.
Transitions
Transitions
Transitions
If the air duct does not fit the air cleaner cabinet opening, gradual
transitions are recommended to reduce air turbulence through the air
cleaner and maximize efficiency. Not more than 20° (about 4” per running
foot) of expansion should be used on each side of the transition fitting.
Basement Furnace
(Lowboy) -Mounted
horizontally in return
plenum– just above
the furnace.
Space Saver
Furnace
(Highboy)- Side
installation.
Mounted
vertically, where
return air enters
side inlet of
furnace.
Counterflow
Furnace–
Mounted
horizontally in
return duct–
just above the
furnace.
Maximum 4" drop
per linear foot
Air Flow
Air Flow
Before
After
Furnace
Horizontal Furnace–
Mounted vertically in return
duct as close to the furnace
as possible.
Offset Installation– If there is less
than 7-in. for mounting the air
cleaner between the duct and the
furnace, move the return air drop.
Air Cleaner
Transition section
4
5
|