TIC Speaker AS P25 User Manual

Architectural Outdoor Patio Speaker Models  
ASP25/ ASP60/ ASP120 & ASP100 models  
TIC Outdoor OmniSpeakers Feature  
Weatherproof Design  
Pair of Patio Speakers  
Brackets included  
Full range 50 - 120W 2-way or 3-way  
speaker drivers (model dependent)  
4”-6.5” acoustic drivers  
1” aluminum tweeters  
Surge protected Revchem®  
Teflon® sealed  
8 Ohm Impedance  
ASP60 & ASP120 w/70v optional for  
Commercial Installations  
180° multi mount system  
ABS Impact Resistant Formulated  
Enclosure  
Black (B) or White (W) finish  
©TIC Corporation U.S.A.  
 
Index…  
Introduction ………………….……………  
Component List …………………….…….  
Pre-Installation …………………… ……..  
Connection Cable ……… ……………....  
3
4
4
5
Exterior Installation ……………………… 5/6  
Maintenance ………………………………  
Customer Service ………………..………  
Warranty …………………………..………  
Trouble Shooting ……...…………….…...  
7
7
7
9
Technical Specifications …………….….. 10  
Thank You for purchasing another high quality audio  
product from TIC Corporation. Please read the enclosed  
installation guidelines carefully and thoroughly to ensure  
years of trouble free service from your new TIC exterior  
audio products.  
Carefully unpack your new TIC exterior product and  
save all packaging materials for possible future use. Check  
that your new TIC product contains all system parts  
detailed in the Components list. Do not attempt to operate,  
install or use your new TIC product if any components  
appear missing or damaged. If so, please notify TIC  
Corporation or your TIC Dealer as soon as possible.  
!WARNING! to avoid possible suffocation or injury please  
keep all plastic bags away from children and pets.  
 
Component List…  
2x  
2x  
Outdoor Patio Speakers  
Mounting swivel brackets and  
screw connectors per pair  
Include optional 70v switching  
assemblies  
ASP60 & ASP120  
models  
New product offer (enclosed  
with literature)  
1x  
1x  
1x  
Instruction Manual  
Warranty Card  
Pre-Installation…  
Need Professional Help?  
Please read this owners guide carefully before installation. Failure to follow  
these instructions fully or incorrect installation may damage your new TIC  
products and any third party equipment used in your new system installation.  
This may also Void any warranty for your new TIC products. If you are unsure  
of your ability to fully understand and fully complete the installation of this TIC  
product, please consult a professional installer.  
Note: TIC Corporation always recommends that you test your product and its  
components prior to exterior installation. Test your components near a mains  
power and, if required, receiver amplifiers source somewhere convenient,  
perhaps inside. Ensure all components are working smoothly and correctly  
before exterior placement and operation.  
 
Exterior Installation…  
Before you begin the installation of your new TIC outdoor product, please  
carefully select the locations of your new TIC products noting any impediments  
or obstacles in the wiring path.  
In general;  
1. Select a reasonably clean, reasonably structurally sound surface for  
the installation of your new TIC outdoor patio speakers. This will  
prevent movement or excessive vibration during use. This will also  
ensure more uniform sound dispersion.  
2. Ensure your new TIC outdoor speaker cables or power source if  
required, can easily reach your new speakers. Ensuring that there are  
no obstructions or difficulties such as concrete paths or architectural  
feature impediments. If the cable is surface mounted you must make  
sure the cable is placed where it cannot be tripped over, pulled,  
abraded or crushed.  
3. Wherever possible avoid long term exposure of your new TIC outdoor  
speakers to chlorinated solvents, acids such as those often contained  
in fertilizers and other solvents which have the potential to eventually  
wear the components prematurely.  
4. When installing either burial cable or TIC’s in-ground outdoor speakers  
please be very aware of any existing in-wall cable, submerged  
plumbing, piping such as sprinklers or irrigation and any sub-surface  
wiring already in place.  
Carefully unpack and check components  
Run speaker test prior to exterior installation  
 
A note on Speaker Cable;  
TIC recommends the use of our SPC30, 50 or 100’ double insulated high  
quality speaker cable, however just about any reasonable speaker cable may  
be used including existing runs that may be in place. For standard 8  
installations of 10 – 25ft., just about any 16/18 gauge 2 core cables can usually  
be used although we would prefer a double insulated or burial spec cable be  
used. For longer runs of 25 – 100ft. 10/14 gauge cable can be used however  
resistance down the line will become a contributing factor.  
Please visit TIC Corporations website at www.ticcorp.com and review the  
Audio Installation Basics articles under Technical Resources for more in depth  
exterior audio and cable guidelines.  
An Important note on Polarity!  
Pleasure proper polarity when connecting your new TIC outdoor speakers.  
This is very important and will result in poor sound reproduction and possibly  
equipment damage if not connected correctly. This is normally avoided by  
ensuring + to + and – to – or as sometimes color coded Red to Red and Black  
to Black from your amplified source to your speakers respectively.  
5. Once you have checked the components and tested the system ready  
for exterior install, recheck your cable runs carefully marking the correct  
channel for each speaker.  
6. Mount your speakers carefully using the supplied mounting brackets for  
each patio speaker.  
7. Connect you new TIC Patio Speakers at the speaker end first ensuring  
enough “play” in the cable to allow angle adjustment as necessary.  
8. Reconnect the speakers to your receiver amplifier being careful to  
ensure correct “Polarity” matching.  
9. *for 70v systems note diagram below;  
TIC ASP60 & ASP120 models only  
 
Once connected properly, test the system at low volume first and then, sit back  
and enjoy another successful installation of a TIC outdoor product!  
Disclaimer;  
TIC Corporation will in no way be held responsible for the improper or  
unsecured installation of this product. Any and all damage arising from the  
installation or use of this product is the purchaser and final installer’s sole  
responsibility.  
Maintenance…  
Occasional maintenance of your TIC products cannot hurt and may help  
greatly. Inspect the installation area regularly removing and twigs, dirt or  
particulate matter from impeding or building up around the output grill area. The  
units may be cleaned using very mild detergents like dishwashing liquid if  
desired. A hose with clean water may also be used but please avoid using high  
pressure or forcing water into the grill or acoustic ports.  
In very cold climates with moderate to heavy snowfall an old trick from the  
major theme parks we supply world wide is to place a plastic bag over the unit  
for the winter or periods it may be not in use or under such snowfall.  
Customer Service…  
For any additional help please contact TIC Corporation at (800) SPX-OMNI, on  
line at www.ticcorp.com , or by email at [email protected] where we would be  
happy to assist you at any time. Also please visit our website for FAQ  
(frequently asked questions) and full contact information.  
Warranty Period…  
TIC Corporation offers a full, UCC approved, one year full parts and labor  
warranty on all its products as standard however there are other 3 and 5 year  
warranties in use with various TIC authorized Dealers world wide. Please check  
your enclosed Warranty card or your Dealer receipt to find out which one  
applies to you. Also please note TIC Corporation General Terms & Conditions  
posted on our website at www.ticcorp.com for further information.  
 
Installation Notes…  
Please note series vs. parallel installation wiring choices below;  
 
Trouble Shooting…  
Problem  
Please Check  
Check the speakers are connected to the cable  
correctly.  
No Sound  
Check the speaker cable is connected to the receiver  
amplifier correctly.  
Check the receiver amplifier is powered “on” at the  
mains, is not on “mute”, has no headphones attached  
and that the Channels used for the exterior speakers  
(usually A or B) is in operation.  
Refer to the owners guide that came with your  
receiver amplifier.  
Most initial problems are simple connectivity, please  
try a different connection cable to your outdoor  
speakers or equipment.  
Check the “balance” control on your receiver  
amplifier.  
Check all connections and cable to the inoperable  
speaker.  
No Sound from one  
speaker  
1. Disconnect the “working” speaker from the  
receiver amplifier connection/ channel. Switch the  
cord from the non-operating speaker from its current  
connection to the “working” speaker connection. If  
the speaker now works the problem is your receiver  
amplifier.  
2. Reconnect as original. Remove the speaker cable  
at the “working” speaker directly and connect it  
directly to the non-working speaker. If the speaker  
now works the problem is somewhere in the original  
speaker cable.  
3. If the speaker still does not work the problem is the  
speaker.  
One speaker sounds  
distorted, lower  
Follow same procedure as above for “No Sound”.  
volume or “different”  
Check the “tone” setting on your receiver amplifier.  
Adjust the Treble and Bass settings on your receiver  
amplifier.  
Treble or Bass  
Check the connections carefully from the amplifier to  
your speakers and ensure correct Phase (+ to + and  
– to – accordingly). Poor sound replication is  
expected from a speakers or speakers out of polarity  
or phase.  
 
General Specifications  
Architectural Outdoor Patio Speakers  
ASP25 - ASP120 Models  
Injection molded PP cones with  
Woofer(s)  
Butyl rubber surround  
Cabinetry Formulated Impact resistant ABS  
Grill Aluminum or Anodized - “sound assist grill”  
*Inches/ lbs  
ASP25  
ASP60  
ASP120  
ASP100  
4.25” woofer  
2” mid-range  
1” aluminum  
tweeter  
5.25” woofer  
1” silk dome  
tweeter  
6.5” woofer  
1” silk dome  
tweeter  
5.25” woofer  
1” aluminum  
tweeter  
Speaker  
Drivers  
Frequency  
response  
59Hz – 19kHz  
45Hz – 19kHz  
35Hz – 19kHz  
60Hz -19kHz  
Sensitivity  
@1W/ 1M  
84db  
86db  
88db  
85db  
Continuous/  
Peak  
25/ 50W  
30/ 75W  
50/ 100W  
25/ 100W  
8x5.5x5  
2.5 Lbs  
8.5x13x6  
6 Lbs  
9.8x7.2x6.5  
5 Lbs  
12x8.6x7.6  
7.5 Lbs  
6.6x5.6x8.9  
3.3 Lbs  
Unit Size  
Unit Wt.  
8.9x15.4x11  
15.5 Lbs  
9.8x17.7x13  
21 Lbs  
16x9.6x8.7  
7.5 Lbs  
Pack Size  
Pack Wt.  
TIC Corporation engages in continual product research and development, new  
materials, production methods and design improvements. TIC Corporation therefore,  
reserves all rights to change or improve products specifications without notice.  
TIC Corporation  
15224 East Stafford Street  
City of Industry, CA. 91744-4418 U.S.A.  
Tel: (626) 968-0211 (5 lines) Fax: (626) 968-1363  
 

Tektronix Telescope 071 0855 05 User Manual
Tektronix Water Dispenser 494A User Manual
Toastmaster Slow Cooker TSC29W User Manual
Topcom Telephone COCOON 85 User Manual
Toshiba Printer EM1 33033 User Manual
Toshiba Satellite TV System P25 S509 User Manual
TP Link Network Router TD W8901G User Manual
Tripp Lite Switch P772 015 User Manual
Ultra Start Remote Starter 32xx Series User Manual
VTech Cordless Telephone CS6649 User Manual