Sony Home Security System BRCSDP12 User Manual

Sony Electronics Inc.  
1 Sony Drive  
Park Ridge, NJ 07656  
Outdoor and Indoor Dome Housings  
Installation and Operation Instructions for the following models:  
BRCSDP12  
(1) Housing  
(1) Supplied Parts  
(1) Power connector (Heather/blower)  
(1) Toolhead driver  
(1) Operation Instruction Manual  
 
INSTALLING THE CAMERA  
WIRING  
1
Install the Sony BRC300 pan/tilt onto the quick release  
bracket using the (4) screws provided with the camera  
(Figure 4).  
CHART A WIRING COLOR CODE  
POWER AND CONTROL INPUTS  
POWER  
1
2
3
4
Camera Power (12 VDC)  
Camera Power (12 VDC)  
Heater & Blower Power (24 VAC) Yellow  
Heater & Blower Power (24 VAC) Green  
Red  
Orange  
NOTE: Failure to provide power to heater and blower will  
void the warranties on both the housing and camera.  
OPTIONAL  
1
2
3
4
Alarm 1  
Alarm 2  
Alarm 3  
Common  
Blue  
Violet  
Gray  
White  
Figure 4  
2
Place the Sony BRC300 pan/tilt and quick release bracket  
in the housing, sliding the three open screw slots over the  
screws in the housing. Slide the bracket forward, then tighten  
the captive screw on the bracket (Figures 5, 6, and 7).  
CHART B POWER AND CONTROL OUTPUTS  
CAMERA POWER  
Camera Power (12 VDC)  
Camera Power (12 VDC)  
1
2
Red  
Orange  
Connect the power plug to the camera per Sony SNCRZ30N  
instructions.  
OPTIONAL  
1
2
3
4
Alarm 1  
Alarm 2  
Alarm 3  
Common  
Blue  
Violet  
Gray  
White  
Figure 5  
24k VAC Wiring Distances  
The following are the recommended maximum distances for 24 VAC  
with a 10% voltage drop (10% is generally the maximum allowable  
voltage drop for AC powered devices).  
Wire Gauge  
Total vA  
consumed  
50  
20  
18  
16  
14  
12  
10  
22  
56  
90 143 228 362 576  
35  
Figure 6  
Figure 7  
© 2003 by Sony Corporation  
10/13/04  
2
 
IMPORTANT SAFEGUARDS  
SAFETY PRECAUTIONS  
1
2
3
Read Instructions - All the safety and operating instructions  
should be read before the unit is operated.  
CAUTION  
Retain Instructions - The safety and operating instructions  
should be retained for future reference.  
RISK OF ELECTRIC SHOCK  
DO NOT OPEN  
!
Heed Warnings - All warnings on the unit and in the operat-  
ing instructions should be adhered to.  
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,  
DO NOT REMOVE COVER (OR BACK).  
4
5
6
Follow Instructions - All operating and user instructions  
should be followed.  
NO USER SERVICEABLE PARTS INSIDE.  
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL  
Electrical Connections - Only a qualified electrician should  
make electrical connections..  
The lightning flash with an arrowhead symbol, within  
an equilateral triangle, is intended to alert the user to the  
presence of non-insulated “dangerous voltage” within the  
product’s enclosure that may be of sufficient magnitude to  
constitute a risk of electric shock to persons.  
Attachments - Do not use attachments not recommended by  
the product manufacturer as they may cause hazards.  
Cable Runs - All cable runs must be within permissible  
distance  
7
8
Mounting - This unit must be properly and securely  
mounted to a supporting structure capable of sustaining the  
weight of the unit. Accordingly:  
The exclamation point within an equilateral triangle is  
intended to alert the user to presence of important operating  
and maintenance (servicing) instructions in the literature  
accompanying the appliance.  
!
a. The installation should be made by a qualified installer.  
b. The installation should be in compliance with local  
codes.  
UNPACKING  
c. Care should be exercised to select suitable hardware to  
install the unit, taking into account both the composition  
of the mounting surface and the weight of the unit. Be  
sure to periodically examine the unit and the supporting  
structure to make sure that the integrity of the in stalla-  
tion is intact. Failure to comply with the foregoing  
could result in the unit separating from the support  
structure and falling, with resultant damages or injury to  
anyone or anything struck by the falling unit.  
Unpack carefully. Electronic components can be damaged if improperly  
handled or dropped. If an item appears to have been damaged in ship-  
ment, replace it properly in its carton and notify the shipper.  
Be sure to save:  
1
The shipping carton and packaging material. They are the safest  
material in which to make future shipments of the equipment.  
2
These Installation and Operating Instructions.  
SERVICE  
If technical support or service is needed, contact Sony at the following  
number:  
TECHNICAL SUPPORT  
8:15AM to 7:30PM (Eastern Time)  
1-800-883-6817  
© 2003 by Sony Corporation  
10/13/04  
5
 

Sennheiser Headphones RS 65 User Manual
Sony Clock Radio ICF CD814 User Manual
Sony Digital Camera XCD V60CR SX90CR U100CR User Manual
Sony Ericsson Cell Phone MK16a User Manual
Sony Speaker SRS A205 User Manual
Spectra Radio KT2042 User Manual
Speed Queen Clothes Dryer HE4030 User Manual
Star Micronics Printer LC 8021 User Manual
Stiga Lawn Mower 8211 0072 80 User Manual
Sunrise Medical Mobility Aid 479610 User Manual