CX 6 travel
Instructions for use
Adjustment to the ear
Bending the ear hook
̈ Position the ear canal phones on the ear and guide
the ear hook behind the ear (L - left or R - right) as
shown.
̈ Bend the ear hook to ensure an optimum fit on the
ear.
̈ Adjust the cable length using the cable slider.
Replacing the earpads
̈ Carefully remove the earpads from the ear canal
phones.
̈ Mount the new earpads to the ear canal phones.
2
Connecting the in-flight adapter
Danger of damage to the device!
CAUTION!
On some aircraft there is a small 2.5 mm
jack socket as part of the audio socket.
This small socket is DC power for aircraft-
issue ANR (Active Noise Reducing)
headphones and is not used by the CX 6
travel.
̈ Use the supplied in-flight adapter to
connect the CX 6 travel only to 3.5 mm
jack sockets
.
The supplied in-flight adapter is for connection to the
in-flight entertainment system of the aircraft.
Note
When operating the ear canal phones in the aircraft,
always use the in-flight adapter!
̈ Fold out the second jack plug of the in-flight adapter
if there are two jack sockets (double mono) in the
aircraft.
̈ Plug the in-flight adapter onto the jack plug of the
ear canal phones.
̈ Connect the in-flight adapter to the 3.5 mm stereo
socket or the twin 3.5 mm mono sockets in the
aircraft.
3
Transporting the ear canal phones
̈ Stow the ear canal phones, the in-flight adapter and
the cleaning tool in the storage box as shown.
4
Cleaning the ear canal phones
Liquids can damage the electronics of
CAUTION!
the ear canal phones!
Liquids entering the housing of the ear
canal phones can cause a short-circuit
and damage the electronics.
̈ Use only a slightly damp cloth to clean
the ear canal phones. Do not use any
solvents or cleansing agents.
Danger of damage to the device!
NOTICE!
Ear wax and tallow buildup can clog the
ear canal phones and lower the sound
quality or even damage the diaphragm.
̈ Use only the supplied cleaning tool to
clean the ear canal phones.
̈ Carefully remove buildup from the mesh using the
cleaning tool.
̈ Clean the ear canal phones regularly.
Note:
For reasons of hygiene, the earpads should be
replaced from time to time (see page 2). Spare
earpads are available from your Sennheiser dealer.
5
Specifications
Weight of the ear-canal- 13 g
phones
5 g
without cable
Connector
3.5 mm stereo jack
1.2 m
Cable length
Temperature range
Impedance
–10 to 55 °C
16 Ω
Frequency response
10–18,000 Hz
Noise attenuation
(passive)
up to 90% / 20 dB
115 dB SPL
Sound pressure level
THD
< 0.1% at 1 kHz,
100 dB SPL
Accessories/spare parts
Accessories and spare parts are available from your
Sennheiser partner.
̈ Only use original Sennheiser accessories and spare
parts.
A list of the suitable accessories/spare parts can be
found on the Sennheiser homepage:
6
Sennheiser electronic GmbH & Co. KG
Am Labor 1
30900 Wedemark, Germany
Phone +49 (5130) 600 0
Fax +49 (5130) 600 300
Printed in China
Publ. 06/08
525750/A01
|