Ryobi Outdoor Trimmer RGT2500 User Guide

Install the spring over the  
spindle. Insert each end of  
the cutting line through the  
eyelets in the cutting head  
assembly and lower the  
spool while feeding the line  
as illustrated in Fig 16.  
CLEANING & STORAGE  
WARNING: Always turn off your trimmer before  
Fig 16  
RYOBI TECHNOLOGIES AUSTRALIA PTY. LTD.  
you clean or perform maintenance on it. Failure  
to do so could result in serious personal injury.  
GUARANTEE  
OWNER’S OPERATING MANUAL  
GRAS S TRIMMER  
Use a small brush to clean off the outside of the trimmer.  
Do not use strong detergents on plastic housing or han-  
dle, as they can be damaged by household cleaners that  
contain aromatic oils such as pine or lemon and by sol-  
vents such as kerosene. Wipe off any moisture with a soft  
cloth.  
Subject to the guarantee condition below, this Ryobi tool which it was not-designed or is not suited; and no  
(hereinafter called “the product”) is guaranteed by Ryobi repairs, alterations or modifications have been attempt-  
MODEL RGT2 5 0 0  
Once the spool is in place,  
apply pressure on the spool  
compressing the spring.  
Pull each end of the line  
sharply to unlock the line  
from the slots. Continue to  
apply pressure to the spool  
until the knob can be  
threaded clockwise onto  
the spindle. Tighten the knob securely. Fig 17.  
(hereinafter called “the Company”) to be free from  
ed by other than an Authorised Service Agent. This  
Fig 17  
defects in material or workmanship for a period of 12 guarantee will not apply if the tool is damaged by acci-  
months from the date of original purchase covering both dent or if repairs arise from normal wear and tear.  
STORAGE  
parts and labour. Under the terms of this guarantee, the  
The Company accepts no additional liability pursuant to  
repair or replacement of any part shall be the opinion of this guarantee for the costs of travelling or transporta-  
If the trimmer will be stored for an extended period of  
time, use the following storage procedure:  
the Company or its authorised agent. Should service  
become necessary during the guarantee period, the  
tion of the Product or parts to and from the service deal-  
er or agent - which costs are not included in this guar-  
owner should contact the Authorised Ryobi Retailer antee.  
from whom the Product was purchased, or the nearest Certain legislation, including the Trade Practices Act,  
1. Drain all fuel from the fuel tank into a container.  
2. Start the motor and allow it to run until it stalls. This  
ensures that all the fuel has been drained from the  
carburetor.  
Company Branch Office. In order to obtain guarantee  
service, the owner must present the sales docket and give rights to the buyer and impose liability on the sell-  
Guarantee Certificate to confirm date of purchase. This er in certain circumstances. Nothing herein shall have  
product is sold by the dealer or agent as principal and the effect of excluding, restricting or modifying any con-  
the dealer has no authority from the Company to give dition, guarantee, right or liability imposed, to the extent  
any additional guarantee on the Companys behalf only that such exclusion, restriction or modification  
1974 (as amended) and other state and territorial laws  
3. Allow the motor to cool. Remove the spark plug and  
put  
approximately 30ml of any high quality oil or 2  
AIR FILTER  
stroke oil  
rope slowly to distribute  
into the cylinder. Pull the starter  
the oil. Reinstall the spark  
It is recommended that the air filter is cleaned on a regular  
basis.To clean the air filter, depress the air filter cover  
latch and remove the cover. Fig 18.  
except as herein contained or herein referred to.  
would render any term herein void.  
plug. Leave the spark plug  
for storage.  
wire off  
Guarantee Conditions  
This guarantee only applies provided that the Product  
has been used in accordance with the manufacturers  
recommendations under normal use and reasonable  
care (in the opinion of the Company) and such guarantee  
does not cover damage, malfunction or failure resulting  
from misuse, neglect, abuse, or used for a purpose for  
4. Inspect for any damaged or loose parts. Repair or  
replace any damaged parts and tighten loose screws,  
nuts or bolts.  
Fig 18  
Cover  
Latch  
SPECIFICATION  
RYOBI TECHNOLOGIES AUSTRALIA PTY. LTD.  
Motor..........................25cc 2 Stroke  
Ignition........................Electronic  
Carburetor ..................Diaphragm, all position  
Cutting Head ..............Twin line bump feed  
Cutting Line ................2.0 mm  
A.C.N. 002 277 509 Incorporated in N.S.W.  
SYDNEY: 359-361 Horsley Road, Milperra, N.S.W.  
2214, Phone: (02) 9772 2444  
email: info@ryobi.aust.com  
Width Of Cut ..............43 cm  
Fuel Mixture: ..............25:1  
Weight ........................4.8 kg  
MELBOURNE: 960 Stud Road, Rowville, Vic, 3178,  
PERTH:  
33-35 Sorbonne Crescent, Canning Vale,  
WA, 6155, Phone: (08) 9455 7775  
Phone: (03) 9764 8655  
HOBART:  
All Enquiries Phone: 1300 361 505  
All Enquiries Phone: 1300 361 505  
ADELAIDE:  
All Enquiries Phone: 1300 361 505  
Remove and wash the filter with soap and water.  
Allow to completely air dry before replacing the filter.  
After replacing the filter secure the air filter cover.  
BRISBANE:  
TOWNSVILLE: All Enquiries Phone: 1300 361 505  
RYOBI TECHNOLOGIES NEW ZEALAND LIMITED  
Auckland: 503 Mt Wellington Highway,  
Mt Wellington, NZ, Phone: (09) 573 0230  
email: info@ryobi.co.nz  
THIS GUARANTEE FORM  
SHOULD BE RETAINED BY THE CUSTOMER AT ALL TIMES  
THANK YOU FOR BUYING A RYOBI TRIMMER.  
For your record and to assist in establishing date of purchase (necessary for in-guarantee service)  
please keep your purchase docket and this form completed with the following particulars.  
Your new Trimmer has been engineered and manufactured to Ryobi's high standard for dependabili-  
ty, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trou-  
ble free performance.  
PURCHASED FROM _______________________________________________________  
ADDRESS OF DEALER _____________________________________________________  
DATE_________________MODEL NO ___________SERIAL NO ___________________  
CAUTION: Carefully read through this entire ow ner's m anual before using your  
new Trim m er.  
Pay close attention to the Rules for Safe Operation, Warnings and Cautions. If you use your Trimmer  
properly and only for what it is intended, you will enjoy years of safe, reliable service.  
Present This Form With Your Purchase Docket When Guarantee Service Is Required  
Page 5  
Thank You again for buying Ryobi tools.  
 

Raypak Boiler 302BE 902BE User Guide
Roland Music Mixer M 300 User Guide
Salton Waffle Iron WM 1186 User Guide
Samsung Printer ML 2510 User Guide
Sanyo Heat Pump 24THS32 User Guide
Sanyo Projector PLC SU50S User Guide
Sanyo Projector PLC SU60 User Guide
Sanyo Stereo System DC MX30 User Guide
SATO Printer XL4xxe User Guide
Sears Edger 53679751 User Guide