RocketFish Home Theater System RF RBAUX User Guide

Please read before setting up your system.  
Every Rocketboost network must contain at least one hub device, which directs network data traꢂc and helps devices  
join the network. The network can have only one hub, which can be enabled by using the hub switch on the back of all  
Rocketboost transmitters. See your User Guide for instructions on joining devices to the network.  
Package contents:  
TM  
AC cable  
Wireless receiver  
User Guide  
Quick Setup  
Cable spool  
IR remote  
3 ft. speaker cable (2)  
9
SPEAKER-OUT (4-8 Ohm)  
10  
Receiver  
AC IN  
120V~,60Hz  
TM  
11  
12  
14  
13  
11 Removable cable spool slot  
12 AC IN connector  
1
2
3
4
5
6
7
8
9
Standby LED  
Power/Join button  
Power/Join indicator  
Bass button  
13 Removable cable spool slot  
14 SPEAKER OUT jacks  
BASS indicator  
SOURCE indicator  
SOURCE button  
HD indicator  
2
3
1
4
5
6
8
7
IR sensor  
10 VOLUME knob  
Step 1 Preparing the remote control  
Toactivatethebattery:  
Removethetabfromthebottomoftheremotecontroltoenablethebattery.  
Connect the right surround  
Step 2 Connecting the receiver  
speaker to the right speaker  
terminal of the receiver, using  
the supplied three-foot speaker  
cable. Connect the red  
SPEAKER-OUT (4-8 Ohm)  
speaker cord to the red (+)  
terminals, and the black speaker  
cord to the black (-) terminals.  
Repeat to connect the left  
speaker.  
AC IN  
120V~,60Hz  
R
L
Step 3 Establishing communication  
Topoweronandswitchtojoiningmode:  
1 Press and hold the button on the hub unit (the hub will be identiꢀed by a solid green power LED or ꢁashing green if there  
are no other devices connected to the network) formorethanthree secondsto put theunitintojoiningmode.  
Theunitwillstayinjoiningmodeforabout30seconds.  
• The Power/Join indicator starts blinking fast.  
2 Press and hold the button on the Rocketꢀsh receiver for more than 3 seconds to put the unit into joining mode.  
The unit will stay in joining mode for 30 seconds.  
The Power/Join indicator starts blinking quickly. When connected, both units will show a solid LED for successful connection.  
• If the Power/Join indicator blinks at a slower rate, the link is not successful. Retry the joining operation.  
See your User Guide for additional information.  
09-0476  
 
QUICK SETUP GUIDE  

Radio Shack Medical Alarms 43 231C User Guide
RCA TV Antenna ANT525 User Guide
Renesas Computer Hardware H8SX 1520 User Guide
Roberts Radio Portable Radio R737 User Guide
Samsung Projection Television HLN5065W User Guide
Saturn Automobile 2008 Aura User Guide
Sceptre Technologies Flat Panel Television X195 User Guide
Schumacher Automobile Battery Charger IP 1875C User Guide
Sears Cooktop 32025 User Guide
SECO LARM USA Door SD 997A User Guide