Philips Treadmill 8500 User Manual

Life Fitness Models 9000HR, 8500, and T9i Treadmills  
How To... Replace the DC Controller Assembly  
Tools Required: Phillips screwdriver, wire cutters  
Main Cable  
1. Turn the unit power OFF at the ON/OFF switch, and then  
unplug the line cord at the wall outlet.  
2. Remove the four Phillips SCREWS securing the MOTOR  
COVER to the FRAME. Lift off the motor cover and set it  
aside.  
3. Remove CABLE TIES along the CROSS FRAME.  
4. Remove the four SCREWS from the front of the unit and  
lift out the DC CONTROLLER to access the wiring.  
DC Controller  
Mounting Screws(4)  
5. To ensure correct wiring locations, mark all wiring  
connectors on the DC CONTROLLER before removal.  
Once all wires are tagged and identified, disconnect  
connectors at the back of the DC CONTROLLER.  
DC Controller  
White  
Black  
6. Install the provided 120V or 230V POWER / LINE FILTER  
CABLE as shown in FIGURES A and B.  
7. Install the provided VOLTAGE JUMPER as shown in  
FIGURE C.  
Note: The New DC Controller will be equipped with a  
Cable / Connector instead of a surface mount connector  
(P1) found on the previous version. This connector  
attaches to the 3-pin connector coming from the treadmills  
line filter.  
Green  
8. Install the DC Controller Board in reverse order of  
removal.  
FIGURE A - 100+ Volt Configuration  
White  
Black  
Green  
FIGURE B - 220+ Volt Configuration  
FIGURE C - Voltage Jumper  
M051-00K60-A017  
 

Pelonis Yard Vacuum V7400 User Manual
Perreaux Digital Camera 6200B User Manual
Pharos Science Applications GPS Receiver iGPS BT II User Manual
Philips TV Antenna SDV5122 User Manual
Philips VCR VPA115AT User Manual
Philips VCR VR253 User Manual
Pioneer Flat Panel Television PRO 920HD User Manual
Polaroid Flat Panel Television PLA 4250A User Manual
Porter Cable Drill 2620 User Manual
Proxima ASA Projector 6150 6100 User Manual