XtraHS_QSG_VOIP841_US-EN.qxd 19.01.2007 21:40 Seite 1
Connect
Install
What’s in the box
1
2
Two 750mAh
AAA NiMH
batteries
Connect the charger
A
Register the handset
Verify the signal strength
Power supply for
charger
A
B
●
●
Insert the plug of the charger
power adapter into the socket on
the bottom of the charger.
Plug the power adapter into your
power outlet.
Registration allows communication
between the base unit and
handset(s). If the handset cannot
communicate with its base, you will
not be able to make any call or use
many of the functions and features on
the phone.
The signal icon
displays the link
status between the handset and the
base unit.
Signal icon
:The handset and base
unit are linked.They can communi-
cate.
No signal icon
:The handset and
Reg.
Handset
Battery door
1.Press
. Register shall be
Charger
base unit have lost link.They are not
able to communicate.Take your
handset closer to the base unit to
reconnect the link.
If you move too far away from the
base unit while you are on the
phone, you will hear warning tones
notifying you that the handset is
almost out of range - lost link.Take
the handset closer to the base unit
or your call will be cut off shortly
after the warning.
highlighted.
2.Enter the system PIN (Default:
Insert batteries
B
Clear
0000). Use
errors.
to correct typing
●
●
Place the 2 rechargeable NiMH
AAA batteries, observing their
polarities, into the battery
compartment on the handset.
Slide the battery door firmly into
place.
Enter
3.Press
●
to confirm.
Your handset starts searching for
the base.
Belt clip
Quick start guide
User manual
4.Press
on the base unit until the
two indications turn off.
If registration is successful, the
signal icon
●
Charge handset
displays steadily.
C
●
What else will you need
Before first use, put the handset
on the charger and charge
batteries for 14 hours.
Note :
Tip :
If your handset has lost link, you
will not be able to make or
receive any call. In addition, you
will not be able to carry out
many of the phone functions and
features.
If registration failed, repeat the
above procedure.
14
Note :
The base can register up to 4
handsets, then the base unit
registration memory is full. If you
attempt to register an additional
handset, the registration process
will be aborted.
AVOIP841
|