Patton electronic Network Router 07M2160 QS User Manual

CopperLink™ Model 2160 Series  
Long Range Ethernet Extender  
Quick Start Guide  
Sales Office: +1 (301) 975-1000  
Part Number: 07M2160-QS, Rev. A  
Revised: December 14, 2009  
Technical Support: +1 (301) 975-1007  
 
Printer  
WAP  
Notebook  
RAID Drive  
Server  
Desktop PC  
Switch  
Desktop PC  
Notebook  
LAN  
DC 9V  
MGMT  
CONSOLE  
LINE  
RST  
+
-
LAN  
Desktop PC  
Laptop computer  
Figure 1. Model 2160 Connection Diagram  
2.0 Choose a configuration method and log in  
There are three methods to configure the Model 2160: serial console, Telnet and Web Browser. You must choose  
one method to configure the Model 2160.  
2.1 Web configuration  
Make sure that an Ethernet Adapter has been installed in the PC or NB you will use to configure the modem.  
TCP/IP protocol is necessary for web configuration, so check if the TCP/IP protocol has been installed.  
The Model 2160 provides a browser interface that allows you to configure and manage the Model 2160. After  
you set up the IP address for the Model 2160, you can access the Web interface applications directly in your  
browser by entering the IP address of the Model 2160. You can then use your Web browser to list and manage  
configuration parameters from a PC.  
Web Configuration requires Internet Explorer 5.0 or later or Netscape Navigator 6.0 and later versions. The rec-  
ommended screen resolution is 1024 by 768 pixels.  
Model 2160 Series Quick Start Guide  
3
 
2.2 Serial console configuration  
For configuring the Model 2160 through the serial console, connect a terminal or a PC equipped with a terminal-  
emulation program (such as Hyper Terminal) to the Model 2160's console port.  
Use the supplied serial cable (RJ-45 to DB9F) to connect the Model 2160 to a PC. After marking the connection,  
configure the terminal-emulation program using the following parameters: 9600 bps , 8 data bits , no parity  
and 1 stop bit.  
2.3 Telnet configuration  
Make sure that an Ethernet Adapter has been installed in the PC or NB you will use to configure the Ethernet  
extender. The Model 2160 also supports Telnet for remote configuration. The command is “telnet 192.168.1.1”  
. For logging into the system through a Telnet connection, “admin” for username and “admin” for password.  
The default IP address is 192.168.1.1. You may change the IP address for your application.  
3.0 Additional information  
For detailed information about installing, configuring, operating, and troubleshooting your Model 2160, refer to  
the Model 2160 Getting Started Guide on the enclosed Patton CD-ROM or at www.patton.com/manuals.  
A.0 Compliance Information  
A.1 Compliance  
EMC:  
FCC Part 15, Class A  
EN55022, Class A  
EN55024  
A.2 Radio and TV Interference (FCC Part 15)  
This equipment generates and uses radio frequency energy, and if not installed and used properly—that is, in  
strict accordance with the manufacturer's instructions—may cause interference to radio and television recep-  
tion. This equipment has been tested and found to comply with the limits for a Class A computing device in accor-  
dance with the specifications in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable  
protection from such interference in a commercial installation. However, there is no guarantee that interference  
will not occur in a particular installation. If the equipment causes interference to radio or television reception,  
which can be determined by disconnecting the cables, try to correct the interference by one or more of the fol-  
lowing measures: moving the computing equipment away from the receiver, re-orienting the receiving antenna,  
and/or plugging the receiving equipment into a different AC outlet (such that the computing equipment and  
receiver are on different branches).  
4
Model 2160 Series Quick Start Guide  
 
A.3 Industry Canada Notice  
This equipment meets the applicable Industry Canada Terminal Equipment Technical Specifications. This is con-  
firmed by the registration number. The abbreviation, IC, before the registration number signifies that registra-  
tion was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications  
were met. It does not imply that Industry Canada approved the equipment.  
This Declaration of Conformity means that the equipment meets certain telecommunications network protective,  
operational and safety requirements. The Department does not guarantee the equipment will operate to the  
user's satisfaction. Before installing this equipment, users should ensure that it is permissible to be connected to  
the facilities of the local telecommunications company. The equipment must also be installed using an acceptable  
method of connection. In some cases, the company’s inside wiring associated with a single line individual service  
may be extended by means of a certified connector assembly (telephone extension cord). The customer should  
be aware that compliance with the above condition may not prevent degradation of service in some situations.  
Repairs to some certified equipment should be made by an authorized maintenance facility designated by the  
supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give  
the telecommunications company cause to request the user to disconnect the equipment. Users should ensure for  
their own protection that the ground connections of the power utility, telephone lines and internal metallic water  
pipe system, are connected together. This protection may be particularly important in rural areas.  
A.4 CE Declaration of Conformity  
We certify that the apparatus described above conforms to the requirements of Council Directive 2004/108/EC  
on the approximation of the laws of the member states relating to electromagnetic compatibility; and Council  
Directive 2006/95/EC on the approximation of the laws of the member states relating to electrical equipment  
designed for use within certain voltage limits.  
The safety advice in the documentation accompanying this product shall be obeyed. The conformity to the above  
directive is indicated by the CE sign on the device.  
A.5 Authorized European Representative  
D R M Green  
European Compliance Services Limited.  
Oakdene House, Oak Road  
Watchfield,  
Swindon, Wilts SN6 8TD, UK  
Model 2160 Series Quick Start Guide  
5
 
Copyright statement  
Copyright © 2009, Patton Electronics Company. All rights reserved.  
The information in this document is subject to change without notice. Patton Electronics assumes no  
liability for errors that may appear in this document.  
Trademarks statement  
The term CopperLink is a trademark of Patton Electronics Company. All other trademarks presented in this docu-  
ment are the property of their respective owners.  
Patton support headquarters in the USA  
Online support: Available at www.patton.com  
E-mail support: E-mail sent to [email protected] will be answered within 1 business day  
Telephone support: Standard telephone support is available five days a week—from 8:00 am to  
5:00 pm EST (1300 to 2200 UTC/GMT)—by calling +1 (301) 975-1007  
Support via VoIP: Contact Patton free of charge by using a VoIP ISP phone to call sip:[email protected]  
Fax: +1 (253) 663-5693  
Alternate Patton support for Europe, Middle East, and Africa (EMEA)  
Telephone support: Standard telephone support is available five days a week—from 8:00 am to  
5:00 pm CET (0900 to 1800 UTC/GMT)—by calling +41 (0)31 985 25 55  
Fax: +41 (0)31 985 25 26  
Note For additional service and support information, refer to the “Contacting Patton for assistance” chapter  
of the CopperLink 2160 Getting Started Guide located on the CD-ROM that came with your CopperLink  
Warranty, Trademark, & Compliance Information  
For warranty, trademark and compliance information, refer to the CopperLink Model 2160 Getting Started Guide  
located on the CD-ROM that came with your NTU or available online at www.patton.com.  
In accordance with the requirements of council directive 2002/96/EC on Waste of  
Electrical and Electronic Equipment (WEEE), ensure that at end-of-life you separate  
this product from other waste and scrap and deliver to the WEEE collection system in  
your country for recycling.  
6
Model 2160 Series Quick Start Guide  
 
NOTES  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
Model 2160 Series Quick Start Guide  
7
 
NOTES  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
8
Model 2160 Series Quick Start Guide  
 

MTD Air Cleaner PPN 41ADY70G000 User Manual
NAD DVD Player T 571 User Manual
Napoleon Fireplaces Indoor Fireplace EF30 User Manual
NETGEAR Network Router WNR200v4 User Manual
New Holland Lawn Mower 157 User Manual
Nostalgia Electrics Blender MSH 105 User Manual
Olympus Microcassette Recorder WS 811 User Manual
Onkyo Speaker System CR 305TX User Manual
Panasonic Cell Phone EB VS2 User Manual
Parasound Stereo Amplifier Zpre2 User Manual