Metra Electronics Computer Drive 99 3009 User Manual

KIT FEATURES  
Shaft and  
DIN unit  
provisions  
99-3009  
INSTALLATION  
INSTRUCTIONS  
KIT COMPONENTS  
Radio Housing  
APPLICATIONS  
CAR  
CHEVROLET  
PAGE  
Camaro 1993-96..........................................................1  
PONTIAC  
Spacer  
Bonneville 1994-99......................................................1  
Firebird 1993...............................................................4  
Firebird 1994-02........................................................ 5  
Grand Am 1996-98......................................................2  
Grand Am 1999-00..................................................... 2  
Grand Prix 1994-96.....................................................3  
Grand Prix 1997-02.....................................................3  
Sunfire 1995-99.......................................................... 4  
Trans Am 1993.............................................................4  
Trans Am 1994-02....................................................... 5  
(1) Keps Nut  
(1) Phillips  
Pan-head Screw  
(1) Carriage Bolt  
TOOLS REQUIRED  
Phillips screwdriver  
Cutting tool  
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION  
Socket wrench  
rev. 090103  
 
PONTIAC Trans Am / Firebird 1994-02  
PONTIAC Grand Am 1996-98  
1
1
2
2
"C"  
"C"  
Disconnect the negative battery terminal to  
prevent an accidental short circuit. Unclip  
the radio trim bezel. Remove (4) 7mm hex-  
head screws securing the factory head unit  
anddisconnectthewiring.  
Cut and remove all mounting tabs on the  
Radio Housing EXCEPT tabs "C". The  
mounting tabs can be identified by the  
stamped letter on the back of each tab. Skip  
to the Installation Instructions for ALL  
VEHICLES on Page #5.  
Disconnect the negative battery terminal to  
prevent an accidental short circuit. Remove  
(2) Phillips screws from the pocket. Remove  
(2) Phillips screws above the instrument  
cluster. Unclip the dash trim bezel and  
Cut and remove all mounting tabs on the  
Radio Housing EXCEPT tabs "C". The  
mounting tabs can be identified by the  
stamped letter on the back of each tab. Skip  
to the Installation Instructions for ALL  
VEHICLES on Page #5.  
remove.  
Remove (3) 7mm hex-head  
screws securing the factory head unit and  
disconnectthewiring.  
ALL VEHICLES  
PONTIAC Grand Am 1999-00  
3
Fig.
1
2
*OPTIONAL  
Illustration not  
available when  
printed  
Fig. B  
"C"  
2-SHAFT HEAD UNITS: Slide the aftermarket head unit into the kit and secure with shaft  
nuts. (seeFig. A)  
Cut and remove all mounting tabs on the  
Radio Housing EXCEPT tabs "C". The  
mounting tabs can be identified by the  
stamped letter on the back of each tab. Skip  
to the Installation Instructions for ALL  
VEHICLES on Page #5.  
Disconnect the negative battery terminal to  
prevent an accidental short circuit. Unclip  
the radio trim bezel. Remove (3) 9/32"  
screws securing the factory head unit and  
disconnectthewiring.  
DIN HEAD UNITS: Insert the Spacer* into the Radio Housing. Slide the DIN cage into the kit  
and secure by bending the metal locking tabs down. Slide the aftermarket head unit into the  
cage until secure. (see Fig. B)  
5
2
 
PONTIAC Grand Prix 1994-02  
PONTIAC Sunfire 1995-99  
1
2
1
2
"C"  
Fig. A  
"C"  
Disconnect the negative battery terminal to  
prevent an accidental short circuit. Using a  
small set of pliers, grasp the retaining clip on  
the back of the gear shifter handle and  
remove the clip. Remove the gear shifter  
handle. Unclip the center console and  
Cut and remove all mounting tabs on the  
Radio Housing EXCEPT tabs "C". The  
mounting tabs can be identified by the  
stamped letter on the back of each tab. Skip  
to the Installation Instructions for ALL  
VEHICLES on Page #5.  
Disconnect the negative battery terminal to  
prevent an accidental short circuit. Open  
the glove box and remove (2) Phillips screws  
exposed on the right edge of the radio trim  
Fig. B  
bezel.  
Unclip the bezel and remove.  
Cut and remove all mounting tabs on the  
Radio Housing EXCEPT tabs "C". (see  
Fig. A). Using a dremel tool, cut and remove  
the shaded portions of the sub-dash plastic.  
This will provide the necessary depth for  
installation. (see Fig. B). Skip to the  
Installation Instructions for ALL VEHICLES  
on Page #5.  
Remove (2) 7mm hex-head screws securing  
the factory head unit and disconnect the  
wiring.  
remove.  
Remove (2) 7mm hex-head  
screws exposed under the climate controls.  
Unclip the radio trim bezel and remove.  
Remove (2) 7mm hex-head screws securing  
the factory head unit and disconnect the  
wiring.  
PONTIAC Trans Am / Firebird 1993  
PONTIAC Grand Prix 1997-99  
1
2
1
2
"B"  
"C"  
Cut and remove all mounting tabs on the  
Radio Housing EXCEPT tabs "B". The  
mounting tabs can be identified by the  
stamped letter on the back of each tab. Skip  
to the Installation Instructions for ALL  
VEHICLES on Page #5.  
Disconnect the negative battery terminal to  
prevent an accidental short circuit. Unclip  
the radio trim bezel. Remove (4) 7mm hex-  
head screws securing the factory head unit  
anddisconnectthewiring.  
Disconnect the negative battery terminal to  
prevent an accidental short circuit. Unclip  
the entire dash trim bezel. Remove the  
screws securing the factory head unit and  
disconnectthewiring.  
Cut and remove all mounting tabs on the  
Radio Housing EXCEPT tabs "C". The  
mounting tabs can be identified by the  
stamped letter on the back of each tab. Skip  
to the Installation Instructions for ALL  
VEHICLES on Page #5.  
3
4
 

La Crosse Technology Clock KWS 8140U IT User Manual
Lenovo Tablet N3S2PUK User Manual
LG Electronics Flat Panel Television RU 42PZ61 User Manual
LG Electronics Washer Dryer WDM 14100FD User Manual
Lincoln Electric Welder US CW139 User Manual
LOREX Technology Computer Monitor SG17LD800 User Manual
Mackie Musical Instrument DX8 User Manual
Magnavox TV VCR Combo CCZ190AT User Manual
Meridian Audio Projector FDP DLPHD20 User Manual
Metz Camcorder Tiros 63 TG 51 100 MT Ibiza SF 63 TG 62 100 MT Morea S 70 TG 65 100 MT Crystal70 TG 53 100 MT Linea deluxe SF 72 TG 67 100 MT User Manual